Found this video on here by.
Diy above ground pool cover.
Crank the handle until the pool cover is all wrapped up around the pipe.
Add a total of 6 inches to each measurement to allow the pvc.
My least favorite chore because it can drive a person or several mad trying to get a cheap pool cover on at the end of a day.
Lift and drag the rolled up cover out of the pool about 3 4 of the way the tilt will allow the water in the layers to drain back in the pool in a few seconds.
Measure the width and length of your swimming pool with a measuring tape.
Lay out the necessary pvc pipes that will make up the length of the.
Make sure that your pool cover is customized and measured to the exact dimensions of your pool.
However unlike purchased covers tarps are rectangular so they pose some challenges to hold in place.
Roll the pool cover out and place it on top making sure it s a loose fit.
Place an air pillow in the center of your pool before the cover is installed.